Quickshifter
System 6
Superbike
- Supersport - Street bike - Supermoto - Motocross |
Quickshifter
- Billet mounting bracket - Internal battery
- Sealed linear sensor |
| |
|
|
|
Benefits: |
|
Superbike regulation and Motocross/Supermoto
gear lever mounted quickshifting for clutchless up-shifts and
without rolling off the throttle (substantially reduced lap times
due to less chassis stress and less suspension movement during
each gearshift, maintains constant drive as well as facilitating
much faster gearshifts) and internal battery for ease of
installation |
|
|
|
Features:
|
|
This system is a
basic quickshifter with an internal 9V battery supply which
allows you to shift up gears at constant or full throttle without
the use of the clutch for lightening up-shifts. This unique
quickshifter design does not require attaching to a power supply
and is specifically designed for Motocross and Supermoto
applications where single cylinder engines cannot benefit from
IntellishiftTM and simplicity is paramount.
This quickshifter
system is available as an inverted race sensor version for
competition use where gears are up for 1st and down for
2nd-3rd-4th-5th-6th.
|
| |
|
|
| TECHNICAL
SPECIFICATIONS: |
| Micro
Logic Control Unit |
Black
ABS, 65mm X 65mm X 28mm |
| PCBs |
Single
sided through hole and surface mount
components |
| Sensor |
Anodized
aluminum housing, marine grade stainless steel shaft, accuracy
+/- 0.10mm, length 162mm between centers, diameter 18mm,
high strength GFN 5mm rod ends, visual interrupt indication,
available as inverted race sensor version 1up - 5down (see order
code below) |
| Installation
summary |
The
Micro-Logic control unit is positioned under either the riders
seat area, typically within the air box area. The sensor
requires adding to the existing gear lever arrangement. The
body end of the sensor is attached either to the frame or and
engine casing etc using the universal fitting kit and the
adjusting rod end of the sensor is attached to the gear lever
mechanism using the universal fitting kit. |
| Wiring
summary |
2-4 wires
to connect. 2 red and black Interrupt cables to be connected
to the ignition coil supply/signal wires as necessary. |
| Order
Code |
QS6
(add the word RACE immediately after the order code if you
require an inverted race sensor version. |
| Pricing |
QS6 -
$349.95 |
| |
|
| |
|
